VLSI viva questions and answers:
1. Why does the present VLSI circuits use MOSFETs instead of BJTs?
Compared to BJTs, MOSFETs can be made very small as they occupy very small silicon area on IC chip and are relatively simple in terms of manufacturing. Moreover digital and memory ICs can be implemented with circuits that use only MOSFETs i.e. no resistors, diodes, etc.
2. What are the various regions of operation of MOSFET? How are those regions used?
MOSFET has three regions of operation: the cut-off region, the triode region, and the saturation region.
The cut-off region and the triode region are used to operate as switch. The saturation region is used to operate as amplifier.
3. What is threshold voltage?
The value of voltage between Gate and Source i.e. VGS at which a sufficient number of mobile electrons accumulate in the channel region to form a conducting channel is called threshold voltage (Vt is positive for NMOS and negative for PMOS).
4. What does it mean "the channel is pinched off"?
For a MOSFET when VGS is greater than Vt, a channel is induced. As we increase VDS current starts flowing from Drain to Source (triode region). When we further increase VDS, till the voltage between gate and channel at the drain end to become Vt, i.e. VGS - VDS = Vt, the channel depth at Drain end decreases almost to zero, and the channel is said to be pinched off. This is where a MOSFET enters saturation region.
5. Explain the three regions of operation of a MOSFET.
Cut-off region: When VGS < Vt, no channel is induced and the MOSFET will be in cut-off region. No current flows.
Triode region: When VGS ≥ Vt, a channel will be induced and current starts flowing if VDS > 0. MOSFET will be in triode region as long as VDS < VGS - Vt.
Saturation region: When VGS ≥ Vt, and VDS ≥ VGS - Vt, the channel will be in saturation mode, where the current value saturates. There will be little or no effect on MOSFET when VDS is further increased.
6. What is channel-length modulation?
In practice, when VDS is further increased beyond saturation point, it does has some effect on the characteristics of the MOSFET. When VDS is increased the channel pinch-off point starts moving away from the Drain and towards the Source. Due to which the effective channel length decreases, and this phenomenon is called as Channel Length Modulation.
7. Explain depletion region.
When a positive voltage is applied across Gate, it causes the free holes (positive charge) to be repelled from the region of substrate under the Gate (the channel region). When these holes are pushed down the substrate they leave behind a carrier-depletion region.
8. What is body effect?
Usually, in an integrated circuit there will be several MOSFETs and in order to maintain cut-off condition for all MOSFETs the body substrate is connected to the most negative power supply (in case of PMOS most positive power supply). Which causes a reverse bias voltage between source and body that effects the transistor operation, by widening the depletion region. The widened depletion region will result in the reduction of channel depth. To restore the channel depth to its normal depth the VGS has to be increased. This is effectively seen as change in the threshold voltage - Vt. This effect, which is caused by applying some voltage to body is known as body effect.
9. Give various factors on which threshold voltage depends.
As discussed in the above question, the Vt depends on the voltage connected to the Body terminal. It also depends on the temperature, the magnitude of Vt decreases by about 2mV for every 1oC rise in temperature.
10. Give the Cross-sectional diagram of the CMOS.
0 Comments
Do leave your comment